cable problems

>  From: "michaelbaessler" <[email protected]>
>Subject: Problem with Purple Cable on Non USA ICR2
>
>I have a problem. I bought a non-USA version of the ICR2 and 
>purchased the purple cable specifically for it. No matter which 
>software I use I either get a message stating that the ICR2 is off or 
>that a cloning cable is not connected to the specified port. Is this 
>due to the fact that the radio is a non US version? I also find that 
>the earphone jack may only be working on one side. I actually have a 
>feeling that this might be causing the problem. If that is so, is 
>there anywhere that I can get this fixed without too much trouble? 
>Any help would be greatly appreciated.

First, what do you mean by "the earphone jack may only be working on one 
side"?  Are you trying to use stereo headphones?  The R2 is a mono device, 
and the earphone jack is designed to drive a mono earphone only.  To use 
stereo heaphones, you need a mono to stereo adapter.  Without that, only one 
ear will get any sound.

If the cable and connections and serial port are all OK, software should be 
able to communicate with the radio at some minimal level, even if it doesn't 
like the fact that the radio is a non-US version.  Most software should talk 
to any version of the radio.

        Dave 


Post message:   [email protected] 
Subscribe:      [email protected] 
Unsubscribe:    [email protected] 
List owner:     [email protected] 
 

Yahoo! Groups Links

To visit your group on the web, go to:
 http://groups.yahoo.com/group/icomr2/

To unsubscribe from this group, send an email to:
 [email protected]

Your use of Yahoo! Groups is subject to:
 http://docs.yahoo.com/info/terms/