Re: Re: using proscan

What port does your device manager say the port is? Don't worry about the baud 
rate in device manager, the software and radio need to match, I use 19.2k also. 
I have had Windows (with an USB to serial converter) assign a port number higher 
than the software can use; i.e. Port 10 or greater. From the device 
manager->Ports>USB Serial Port>Port settings>Advanced> you can change the port 
to a lower number in the range in Proscan/other software will use.

Let us know what solution you find please. I'm always interested in hear what 
fixes things!

Cheers,
Shane
________________________________
From: Geoff <[email protected]>
To: [email protected]
Sent: Sun, April 3, 2011 11:46:12 AM
Subject: [UnidenBC780XLT] Re: using proscan

  
Does bearcat communicate with other software..eg arc780 or is only with 
proscan.that you have problems...Is cable straight through or null modem type or 
is gender changer straight through

Just a few thoughts
Good luck

--- In [email protected], Don <stb55@...> wrote:
>
> The issue is probably Proscan cannot find the port the scanner is connected to. 
>If you have a newer PC/Laptop leave the baud rate on the BC780xlt at 19200. Now 
>go 
>
> to Proscan and try different ports. Let us know what happens.
> 
> Don
> Upland, CA
> 
> On 03-Apr-11 08:16, tonyjenkins37 wrote:
> >
> > Hello
> > I have an issue with this cannot communicate with the scaner i have set the 
>scanner to remote as per instruction changed the baund rate to different 
>settings 
>
> > throught the availble range and am using a gender changer on the back of the 
>scanner the software is try before you but proscan is this the best option any 
>help 
>
> > would be great
> > regards
> > Tony
> >
> > 
> >
> >
> >
> > No virus found in this incoming message.
> > Checked by AVG - www.avg.com
> > Version: 9.0.894 / Virus Database: 271.1.1/3547 - Release Date: 04/02/11 
>11:57:00
> >
>




[Non-text portions of this message have been removed]