RE: RES: LCD lines

Gerry Rolle <[email protected]> Sun, 14 Aug 2011 19:25:33 -0700
Newsgroups gmane.recreation.radio.hardware.yaesu.vr-5000
Message-ID <[email protected]>
If the loss of a few "lines" was the only problem, might be able to live
with it.

However, along with the lines, the display is growing dimmer.

I'm ordering the new software.

 

  _____  

From: [email protected] [mailto:[email protected]] On
Behalf Of majoco21
Sent: Sunday, August 14, 2011 7:12 PM
To: [email protected]
Subject: Re: RES: [YaesuVR-5000] LCD lines

 

  

Hi, 

Plenty of previous posts on this issue. I drilled the top and bottom case
halves to reduce the temperature which it has done, but no change in the
missing lines, both vertical and horizontal. I began to suspect the 100uF
capacitor on the back of the display board (which in my receiver is
parallelled by a 22000uF) and removed both of them and temporarily fitted a
new 22000uF but that made no difference. 

It seems strange that if the powere is removed for a few days, the number of
bad lines is increased but slowly reverts back to a stubborn few - today I
have only two verticals missing which go through the 'tens' of the channel
number. I guess I'll just live with it, or try the new software.

--- In [email protected] <mailto:YaesuVR-5000%40yahoogroups.com>
, "Richard Gerhke" <gerhke@...> wrote:
>
> Hello
> My VR5000 is also introducing LCD failure, is missing a vertical line in
the
> central region of the last character of the clock.
> Sera that Yaesu have this lcd for sale, I see that we are not alone with
> this defect, thequote is found on the internet concerning this problem.
> It no longer as of old equipment.
> 
> 
> 
> Richard Gerhke
> 
> <http://www.gerhke.com> www.gerhke.com
> 
> Brazil 
> 
> 
> 
> De: [email protected] <mailto:YaesuVR-5000%40yahoogroups.com>
[mailto:[email protected] <mailto:YaesuVR-5000%40yahoogroups.com>
] Em
> nome de nisangreenwich
> Enviada em: domingo, 14 de agosto de 2011 11:59
> Para: [email protected] <mailto:YaesuVR-5000%40yahoogroups.com>

> Assunto: [YaesuVR-5000] LCD lines
> 
> 
> 
> 
> 
> Hi guys,
> 
> I have an older vr-5000 which has developed loss of vertical LCD lines. On
> start up there are 5 lines missing and within an our it drops down to 2!
> (heat issue?)
> 
> Any ideas on how to correct this?
> 
> Thanks
> Nisan,
> Dublin
> 
> Sent from my iPad ...
> 
> 
> 
> 
> 
> [Non-text portions of this message have been removed]
>





[Non-text portions of this message have been removed]