Re: [PATCH u-boot v2] ARM: dts: aspeed: Add dts for ASUS Kommando IPMI card

Hi Andrew,

On Mon, May 18, 2026 at 8:40 PM Andrew Jeffery
<[email protected]> wrote:
>
> Perhaps we could add the mac.-clk-delay properties with the default
> values currently used by the driver to the SCU devicetree node for
> those boards. From there, we can rework clk_ast2600 so that the default
> value is no delay from the SCU, and we rely on the devicetrees to
> specify what delay, if any, is required, where necessary.

I've sent a v3 that tries to do this. Let's see if this solution works
for everyone.

>
> From there, no new u-boot ast2600 devicetrees should require the mac.-
> clk-delay properties, and on the MAC nodes we can set `phy-mode =
> "rgmii-id";` as appropriate.
>
> I've added Marc to the thread for the MSX4 side of things.
>
> >
> > I looked through Ender's efforts and it seems surprising that it works
> > for their board. Maybe the board design is different in some manner
> > there?
>
> Yes, that is surprising. I've added Ender to this thread.

Hopefully we can test this on the nvidia board too.

>
> Andrew


-- 
Regards
Anirudh Srinivasan